Skip to content

GENERIC

GENERIC - MediaTek Devices

Generic MediaTek-powered devices and legacy chipsets.

CONNECTION

  • CONNECTION

How to connect device in BROM Mode ?

Created: 2023-10-02 07:24:35

Press Both Volume buttons and connect device in powered OFF State

FACTORY RESET [FORMAT]

  • FACTORY RESET [FORMAT]

How to factory reset device in flash mode?(Old Chipsets)

Created: 2023-10-02 07:24:35

  1. Select MediaTek SoC from home-page.
  2. Tick Preloader mode.
  3. Select Factory Format/Reset from drop down.
  4. Select Erase userdata for method.
  5. Click bootinfo and after successfull bootinfo click execute and wait for the operation to finish
  6. let the device boot, first boot may take time.

Note

Legacy devices may need to load old sp flash tool DA.

RESET FRP

  • RESET FRP

How to remove FRP in Preloader mode?

Created: 2023-10-02 07:24:35

  1. Open MediaTek SoC from home page.
  2. Tick Preloader mode and Select Infinix Method from drop down and do bootinfo.
  3. After succesfull Bootinfo select Factory reset protection from drop down menu in Service tab.
  4. Click execute after selecting Zero Wipe method.
  5. Wait for the operation to finish.

WRITE FIRMWARE

  • WRITE FIRMWARE

How to flash device in Preloader mode?

Created: 2023-10-02 07:24:35

  1. Open MediaTek Module from homepage.
  2. Tick Preloader mode and select Tecno-Infinix method
  3. Go to flash too tab and load the scatter file for your device.
  4. Click bootinfo and connect device in preloader mode.
  5. Click execute for flashing and wait for writing to finish.

READ FIRMWARE BACKUP

  • READ FIRMWARE BACKUP

How to backup Firmware ?

Created: 2023-10-02 07:24:35

  1. Open MediaTek Module and select brand and model.
  2. From Drop down menu in Service Tab select Partitions.
  3. Under the flash mode method select desired way for backup.
  4. Click bootinfo and connect device in flash mode (Brom/Preloader mode).
  5. click execute and wait for the backup to finish.

REPAIR IMEI

  • REPAIR IMEI

How to repair IMEI meta mode ?

Created: 2023-10-02 07:24:35

  1. Open MediaTek Module.
  2. Click on reboot button and double click meta mode auto.
  3. Connect device in flash mode and wait until device is reboot to meta mode.
  4. Go to Repair IMEI Tab and select New Method-Meta from drop down list.
  5. Click execute and wait for the operation to finish.

Warning

This function is for original repair purpose only. Change of any serial is illegal and Tool doesnt promote it.

Navigate back to MediaTek devices or All supported devices